Component Inspection
- CHECK THROTTLE CONTROL MOTOR (BANK 1)
- Turn ignition switch OFF.
- Disconnect electric throttle control actuator (bank 1) harness connector.
- Check the resistance between electric throttle control actuator (bank 1) terminals as per the following.
Electric throttle control actuator (bank 1) Resistance
(Approx.)+ - Terminals 2 1 1 - 15 Ω [at 25°C (77°F)]
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Replace electric throttle control actuator (bank 1). Refer to INTAKE MANIFOLD COLLECTOR : Exploded View .
- CHECK THROTTLE CONTROL MOTOR (BANK 2)
- Turn ignition switch OFF.
- Disconnect electric throttle control actuator (bank 2) harness connector.
- Check the resistance between electric throttle control actuator (bank 2) terminals as per the following.
Electric throttle control actuator (bank 2) Resistance
(Approx.)+ - Terminals 2 1 1 - 15 Ω [at 25°C (77°F)]
Is the inspection result normal?
YES>>
INSPECTION END
NO>>
Replace electric throttle control actuator (bank 2). Refer to INTAKE MANIFOLD COLLECTOR : Exploded View .