Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Refer to Work Procedure .
4. Turn ignition switch ON.
5. Set selector lever to D position.
6. Check the voltage between ECM harness connector terminals under the following conditions.

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   F142	103 [TP sensor 1 (bank 1)]	100	Accelerator pedal	Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   	109 [TP sensor 1 (bank 2)]	121		Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   	114 [TP sensor 2 (bank 1)]	100		Fully released	Less than 4.75
   				Fully depressed	More than 0.36
   	111 [TP sensor 2 (bank 2)]	121		Fully released	Less than 4.75
   				Fully depressed	More than 0.36

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

GO TO 2.

1. Replace malfunctioning electric throttle control actuator.
2. Refer to Work Procedure .

>>

INSPECTION END