Component Inspection
- CHECK FRP SENSOR
WITH CONSULT
- Turn ignition switch OFF.
- Reconnect harness connector disconnected.
- Start the engine.
- Select "DATA MONITOR" mode of "ENGINE" using CONSULT.
- Check that the "FUEL PRES SEN V" indication.
Monitor Item Condition Values/Status FUEL PRES SEN V Engine speed: Idle 1, 140 - 1, 460 mV Engine speed: Revving engine from idle to 4, 000 rpm quickly 1, 300 - 2, 900 mV
WITHOUT CONSULT
- Turn ignition switch OFF.
- Reconnect harness connector disconnected.
- Start the engine.
- Check FRP sensor signal voltage.
ECM Condition Value
(Approx.)Connector + - Terminal F143 47 85 [Engine is running] - Warm-up condition
- Idle speed
1.14 - 1.46 V [Engine is running] - Warm-up condition
- Revving engine from idle to 4, 000 rpm quickly
1.3 - 2.9 V Is the inspection result normal?
YES>>
INSPECTION END
NO>>
Replace FRP sensor. Refer to FUEL INJECTOR AND FUEL TUBE : Exploded View .