Component Inspection

1. Turn ignition switch OFF.
2. Disconnect combination switch (spiral cable) harness connector M301 (Without LDW) or M302 (With LDW).
3. Check resistance between combination switch harness connector terminals under the following conditions.

   Combination switch		Condition	Resistance (Ω)
   Connector	Terminals
   M301*1 M302*2	13 and 16*1 18 and 19*2	MAIN switch: Pressed	Approx. 0
   		DYNAMIC DRIVE ASSISTANCE SYSTEMS switch: Pressed	Approx. 270
   		CANCEL switch: Pressed	Approx. 620
   		DISTANCE switch: Pressed	Approx. 1, 090
   		SET/COAST switch: Pressed	Approx. 1, 810
   		RESUME/ACCELERATE switch: Pressed	Approx. 2, 990
   		All ICC steering switches: Released	Approx. 5, 420

   *1: Without LDW

   *2: With LDW

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace ICC steering switch. Refer to STEERING WHEEL : Removal and Installation .