Component Inspection

1. Turn the ignition switch OFF.
2. Disconnect force motor angle sensor harness connector.
3. Check resistance between force motor angle sensor connector terminals.

   Force motor angle sensor		Condition	Resistance
   Terminal
   3	7	0°C (32°F)	Approx. 34.8 kΩ
   		25°C (77°F)	Approx. 10.0 kΩ
   		40°C (140°F)	Approx. 5.2 kΩ

4. Check continuity between force motor angle sensor connector and ground.

   Force motor angle sensor	-	Continuity
   Terminal
   3	Ground	Not existed
   7

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Force motor temperature sensor is malfunction. Replace steering column assembly. Refer to STEERING COLUMN : Removal and Installation .