Component Inspection

1. Turn the ignition switch OFF.
2. Disconnect sub motor angle sensor harness connector.
3. Check continuity between motor angle sensor connector terminals.

   Sub motor angle sensor		Continuity
   Terminal
   1	2	Not existed
   1	3	Not existed
   1	4	Not existed
   1	5	Existed
   1	6	Not existed
   2	3	Not existed
   2	4	Existed
   2	5	Not existed
   2	6	Not existed
   3	4	Not existed
   3	5	Not existed
   3	6	Existed
   4	5	Not existed
   4	6	Not existed
   5	6	Not existed

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Sub motor angle sensor is malfunction. Replace steering gear assembly. Refer to STEERING GEAR AND LINKAGE : Removal and Installation .