DTC Diagnosis Procedure

1. Check the force motor angle sensor. Refer to Component Inspection .

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Force motor angle sensor is malfunction. Replace steering column assembly. Refer to Removal and Installation .

1. 1. Disconnect steering force control module connector and force motor angle sensor connector.
   2. Check the continuity between control module harness connector and angle sensor harness connector.

      Steering force control module		Force motor angle sensor		Continuity
      Connector	Terminal	Connector	Terminal
      E141	10	M330	1	Yes
      	11		5
      	6		4
      	5		8
      	4		2
      	2		6

   3. Check the continuity between control module harness connector and ground.

      Steering force control module		-	Continuity
      Connector	Terminal
      E141	10	Ground	No
      	11
      	6
      	5
      	4
      	2

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace malfunctioning component.

1. 1. Check enlarged contact spring of terminal. Refer to How to Check Terminal .
   2. Perform intermittent incident while turning steering wheel. Refer to Intermittent Incident .

Is the inspection result normal?

YES>>

Replace steering force control module. Refer to Removal and Installation .

NO>>

Repair or replace malfunctioning component.