Av Control Unit

1. Check that the following fuses are not blown:

   Terminal No.	Signal name	Fuse No.	Capacity
   17	Ignition power supply	55	5A
   19	Battery power supply	42	15A

Are the fuses blown?

YES>>

Replace the blown fuse after repairing the affected circuit.

NO>>

GO TO 2.

1. 1. Ignition switch OFF.
   2. Disconnect AV control unit connector.
   3. Check voltage between AV control unit connector and ground.

      AV control unit		Ground	Condition	Voltage(Approx.)
      Connector	Terminal
      M138	19	-	Ignition switch: OFF	Battery voltage
      	17		Ignition switch: ON

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connectors.

1. 1. Ignition switch OFF.
   2. Check continuity between AV control unit connector and ground.

      AV control unit		Ground	Continuity
      Connector	Terminal
      M138	20	Ground	Yes

Is the inspection result normal?

YES>>

Inspection End

NO>>

Repair or replace harness or connectors.