April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

CHECK DRIVE MODE SELECT SWITCH

Ignition switch OFF.
Disconnect drive mode switch harness connector.

Check the continuity between drive mode switch terminals as follows.

Drive mode switch		Condition	Continuity
Terminals		Condition	Continuity
4	3	Switch to down-position.	Existed
	3	Other than the above.	Not existed
	7	Switch to up-position.	Existed
	7	Other than the above.	Not existed

Is the inspection result normal?

>>

INSPECTION END

>>

Replace drive mode select switch. Refer to Removal and Installation .