Component Function Check

Do you have CONSULT '

>>

GO TO 2.

>>

GO TO 3.

With CONSULT

1. Turn ignition switch ON and engine stopped.
2. On the CONSULT screen, select "ENGINE">>"ACTIVE TEST">>"WASTEGATE ACTUATOR".
3. Operate "Up" or "Down", set "W/G ACTUATOR POSITION B1" to 0.002 m, and make a quick short note of value "V1" of "W/G ACTUATOR POSI SEN B1".
4. Operate "Up" or "Down", set "W/G ACTUATOR POSITION B1" to 0.015 m, and make a quick short note of value "V2" of "W/G ACTUATOR POSI SEN B1".

Do the values of "V1" and "V2" change (visually, ACTUATOR SHAFT operates) and "V2" minus "V1" becomes equal to or more than 2.6V?

>>

INSPECTION END

>>

Replace Turbocharger Assembly (do not replace electric wastegate control actuator only). Refer to Component Location .

Without CONSULT

1. Turn ignition switch OFF.
2. Disconnect Wastegate control actuator harness connector.
3. While checking the POSITION SENSOR OUT voltage with an oscilloscope, apply a voltage of 12 V to the positive or negative terminal.

Does ACTUATOR SHAFT visually operate and POSITION SENSOR OUT voltage change?

>>

INSPECTION END

>>

Replace Turbocharger Assembly (do not replace electric wastegate control actuator only). Refer to Component Location .