April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Description

DTC DETECTION LOGIC

DTC		CONSULT screen terms(Trouble diagnosis content)	DTC detection condition
P10B0	46	ATR control unit[Active torque rod control unit error]	Diagnosis condition	Ignition switch ON
	47		Signal (terminal)	-
	48		Threshold	Malfunction in the internal of ATR control module
	49		Diagnosis delay time	-
	4B

POSSIBLE CAUSE

ATR control module

FAIL-SAFE

ATR control module stops signal to the ATR actuator

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY
If DTC P10B0 is displayed with DTC 10B1, first perform the trouble diagnosis for DTC 10B1.

Is applicable DTC detected?

>>

Perform diagnosis of applicable. Refer to DTC Description .

>>

GO TO 2.
PRECONDITIONING
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

>>

GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON (engine stopped) and wait least 10 seconds.
  CAUTION:
  Never start engine during this procedure.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Check DTC.
Is DTC detected?

>>

Proceed to Diagnosis Procedure .

>>

To check malfunction symptom before repair: Refer to Intermittent Incident .

>>

Confirmation after repair: INSPECTION END