Component Inspection

1. 1. Ignition switch OFF.
   2. Disconnect force motor angle sensor connector.
   3. Check resistance between force motor angle sensor connector pin terminals.

      Force motor angle sensor		Condition	Resistance(Approx.)
      Terminals		Temperature: °F (°C)
      3	7	32 (0)	34.8 kΩ
      		77 (25)	10.0 kΩ
      		104 (40)	5.2 kΩ

   4. Check continuity between force motor angle sensor connector and ground.

      Force motor angle sensor	-	Continuity
      Terminal
      3	Ground	No
      7

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Force motor temperature sensor is malfunctioning. Replace steering column assembly. Refer to Removal and Installation .