DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms(Trouble diagnosis content)	DTC detected condition
C13EE-00	INCOMP CONFIG(Incomplete config)	Diagnosis condition	When engine running.
		Signal (terminal)	-
		Threshold	Configuration of one control module at least in three control modules is wrong or incomplete.
		Diagnosis delay time	1 seconds or more

POSSIBLE CAUSE

Configuration of one control module at least in three control modules is wrong or incomplete.

FAIL-SAFE

Mode 3

NOTE:

For fail-safe mode, refer to Fail-safe .

DTC CONFIRMATION PROCEDURE

PRECONDITIONING
1. If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>

GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Start engine.
    CAUTION:
    Never drive the vehicle.
  2. Select "Self Diagnostic Result" mode of "DAST 2".
Is DTC "C13EE-00" detected?

YES>>

Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO>>

Confirmation after repair: Inspection End.