DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms(Trouble diagnosis content) | DTC detected condition | |
|---|---|---|---|
| C13F2-00 | DIFFERENT SOFTWARE VERSION(Different software version) | Diagnosis condition | When engine running |
| Signal (terminal) | - | ||
| Threshold | The software version of each control module is different. | ||
| Diagnosis delay time | 1 seconds or more | ||
POSSIBLE CAUSE
The software version of steering force control module, steering angle sub control module and steering angle main control module is different.
FAIL-SAFE
Mode 2 or Mode 3
NOTE:
For fail-safe mode, refer to Fail-safe
.
DTC CONFIRMATION PROCEDURE
- PRECONDITIONING
- If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
- DTC REPRODUCTION PROCEDURE
CONSULT
- Ignition switch ON.
- Select "Self Diagnostic Result" mode of r "EPS/DAST 3".
Is DTC "C13F2-00" detected?
YES>>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO>>
Confirmation after repair: Inspection End.