Work Procedure
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
Fully understand the following items well before the road test;
- Precautions: Refer to Precaution for Blind Spot Warning/Blind Spot Intervention System Service .
- System description for Blind Spot Warning: Refer to System Description .
- System description for Blind Spot Intervention: Refer to System Description .
- LDW/LDP SYSTEM ACTION TEST
Perform the LDW/LDP system action test. Refer to Inspection Procedure .
>>
GO TO 2.
- CHECK BSW SYSTEM SETTING
- Start the engine.
- Check that the BSW system setting can be enabled/disabled on the integral switch.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
>>
GO TO 3.
- BSW SYSTEM ACTION TEST
- Enable the setting of the BSW system on the integral switch.
- Turn warning systems switch ON (warning systems ON indicator is ON).NOTE:
Blind Spot Intervention system is OFF.
- Check BSW operation according to the following table.
Vehicle condition/ Driver's operation Action Vehicle speed(Approx.)[km/h (MPH)] Turn signal condition Status of vehicle detection within detection area Indication on the Blind Spot Warning/Blind Spot Intervention indicator Indication on the combination meter Indicator color Buzzer Less than approx.32 (20) - - OFF White OFF Approx.32 (20)or more - Vehicle is absent OFF White OFF OFF Vehicle is detected ON White OFF ON(vehicle detected direction) Before turn signal operates Vehicle is detected Blink Yellow (Blink) Short continuous beeps Vehicle is detected after turn signal operates Blink Yellow (Blink) OFF
>>
GO TO 4.
- CHECK BLIND SPOT INTERVENTION SYSTEM SETTING
- Start the engine.
- Check that the Blind Spot Intervention system setting can be enabled/disabled on the integral switch.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
>>
GO TO 5.
- CHECK WARNING SYSTEM SWITCH
- Start the engine.
- After starting the engine wait for 5 seconds or more.
- Enable the setting of the Blind Spot Intervention system on the integral switch.
- Press the warning system switch.
- Check that the Blind Spot Intervention ON indicator on the combination meter illuminates.
- Check that the Blind Spot Intervention ON indicator turns OFF when the system is turned OFF by pressing the warning system switch.
- Check that the Blind Spot Intervention ON indicator turns OFF when the engine starts again.
NOTE:- The Blind Spot Intervention ON indicator does not illuminate even when the warning system switch is turned ON within approximately 5 seconds after starting the engine.
>>
Inspection End.