DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms(Trouble diagnosis content)	DTC detected condition
C13AD-00	CONTROL MODULE(Control module)	1	Diagnosis condition	When engine running.
			Signal (terminal)	-
			Threshold	The internal malfunction in control module is detected.
			Diagnosis delay time	1 seconds or more
		2	Diagnosis condition	When engine running.
			Signal (terminal)	-
			Threshold	Malfunction of motor circuit is detected.
			Diagnosis delay time	1 seconds or more

POSSIBLE CAUSE

Steering angle main motor
Steering angle main motor harness connector
Motor circuit (between steering angle main control module and steering angle main motor) is open or short.
Steering angle main control module

FAIL-SAFE

Mode 1 or Mode 3

NOTE:

For fail-safe mode, refer to Fail-safe .

DTC CONFIRMATION PROCEDURE

PRECONDITIONING
1. If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>

GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Start the engine.
    CAUTION:
    Never drive the vehicle.
  2. Select "Self Diagnostic Result" mode of "DAST 1".
Is DTC "C13AD-00" detected?

YES>>

Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO>>

Confirmation after repair: Inspection End.