DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms(Trouble diagnosis content) | DTC detected condition | |
|---|---|---|---|
| C13BA-00 | CONTROL MODULE POWER SUPPLY(Control module power supply) | Diagnosis condition | When engine running. |
| Signal (terminal) | - | ||
| Threshold | Control module power supply is less than ≤ 4 V. | ||
| Diagnosis delay time | 1 seconds or more | ||
POSSIBLE CAUSE
- Harness and connector
- Battery
- Fusible link
- Power supply circuit
- Steering angle main control module
FAIL-SAFE
Mode 1 or Mode 3
NOTE:
For fail-safe mode, refer to Fail-safe
.
DTC CONFIRMATION PROCEDURE
- PRECONDITIONING
- If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
- DTC REPRODUCTION PROCEDURE
CONSULT
- Start the engine.CAUTION:
Never drive the vehicle.
- Select "Self Diagnostic Result" mode of "DAST 1".
- Start the engine.
Is DTC "C13BA-00" detected?
YES>>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO>>
Confirmation after repair: Inspection End.