DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms(Trouble diagnosis content) | DTC detected condition | |
|---|---|---|---|
| C13D0-00 | ALC FUNCTION REQUEST SIGNAL(Pro-Pilot Assist function request signal) | Diagnosis condition | When engine running. |
| Signal (terminal) | - | ||
| Threshold | Malfunction is detected in Pro-Pilot Assist signal B that is output from chassis control module. | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
- Harness or connector (Chassis communication line)
- Steering angle main control module
- Chassis control module
FAIL-SAFE
-
DTC CONFIRMATION PROCEDURE
- PRECONDITIONING
- If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
- DTC REPRODUCTION PROCEDURE
CONSULT
- Ignition switch ON.
- Select "Self Diagnostic Result" mode of "DAST 1".
Is DTC "C13D0-00" detected?
YES>>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO>>
Confirmation after repair: Inspection End.