DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms(Trouble diagnosis content)	DTC detected condition
C13DB-00	STEERING TORQUE SENSOR(Steering torque sensor)	1	Diagnosis condition	When engine running.
			Signal (terminal)	Torque sensor main signal
			Threshold	The signal voltage of steering torque sensor is following condition. Main signal voltage < 0.3 V, 4.7 V < Main signal voltage
			Diagnosis delay time	1 second or more continuously
		2	Diagnosis condition	When engine running.
			Signal (terminal)	Torque sensor sub signal
			Threshold	The signal voltage of steering torque sensor is following condition. Sub signal voltage < 0.3 V, 4.7 V < Sub signal voltage
			Diagnosis delay time	1 second or more continuously

POSSIBLE CAUSE

Steering torque sensor
Sensor circuit (between steering angle main control module and steering torque sensor) is open or short.
Steering angle main control module

FAIL-SAFE

Mode 3 (When control module detects a malfunction at startup.)
Mode 2 (When control module detects a malfunction except during startup.)
NOTE: For details of fail-safe mode, refer to Fail-safe .

DTC CONFIRMATION PROCEDURE

PRECONDITIONING
1. If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>

GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Start the engine.
    NOTE: Never drive the vehicle.
  2. Turn the steering wheel.
  3. Select "Self Diagnostic Result" mode of "DAST 1".
Is DTC "C13DB-00" detected?

YES>>

Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO>>

Confirmation after repair: Inspection End.