DTC Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect the electric shift selector connector.
3. Turn ignition switch ON.
4. Check the voltage between electric shift selector vehicle side harness connector terminal and ground.

   Electric shift sensor	+		-	Voltage(Approx.)
   	Electric shift selector
   	Connector	Terminal
   1, 3, 5, 7	M251	18	Ground	5 V
   2, 4, 6, 8		13

Is the inspection result normal?

>>

GO TO 3.

>>

GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect the electric shift control module connector.
3. Check the continuity between the electric shift control module vehicle side harness connector terminal and the electric shift selector vehicle side harness connector terminal.

   Electric shift sensor	Electric shift control module		Electric shift selector		Continuity
   	Connector	Terminal	Connector	Terminal
   1, 3, 5, 7	M242	19	M251	18	Existed
   2, 4, 6, 8	M241	48		13

4. Check the continuity between the electric shift control module vehicle side harness connector terminal and ground.

   Electric shift sensor	Electric shift control module		Ground	Continuity
   	Connector	Terminal
   1, 3, 5, 7	M242	19	Ground	Not existed
   2, 4, 6, 8	M241	48

Is the inspection result normal?

>>

Replace the electric shift control module. Refer to Removal and Installation .

>>

Repair or replace damaged parts.

1. Turn ignition switch OFF.
2. Disconnect the electric shift control module connector.
3. Check the continuity between the electric shift control module vehicle side harness connector terminal and the electric shift selector vehicle side harness connector terminal.

   Electric shift sensor	Electric shift control module		Electric shift selector		Continuity
   	Connector	Terminal	Connector	Terminal
   1, 3, 5, 7	M241	41	M251	12	Existed
   2, 4, 6, 8		50		24

4. Check the continuity between the electric shift control module vehicle side harness connector terminal and ground.

   Electric shift sensor	Electric shift control module		Ground	Continuity
   	Connector	Terminal
   1, 3, 5, 7	M241	41	Ground	Not existed
   2, 4, 6, 8		50

Is the inspection result normal?

>>

GO TO 4.

>>

Repair or replace damaged parts.

1. Check the continuity between the electric shift control module vehicle side harness connector terminal and the electric shift selector vehicle side harness connector terminal.

   Electric shift sensor	Electric shift control module		Electric shift selector		Continuity
   	Connector	terminal	Connector	terminal
   1	M241	34	M251	2	Existed
   3		36		3
   5		44		4
   7		39		5
   2		35		14
   4		37		15
   6		45		16
   8		40		17

2. Check the continuity between the electric shift control module vehicle side harness connector terminals and ground.

   Electric shift sensor	Electric shift control module		Ground	Continuity
   	Connector	terminal
   1	M241	34	Ground	Not existed
   3		36
   5		44
   7		39
   2		35
   4		37
   6		45
   8		40

Is the inspection result normal?

>>

Replace the electric shift selector. Refer to Removal and Installation .

>>

Repair or replace damaged parts.