Work Procedure
- Since vehicle specifications are not included in the lane camera unit after replacement, it is required to write vehicle specifications with CONSULT.
- Configuration has three functions as follows.
Function Description Read/Write Configuration Before Replace ECU Allows the reading of vehicle specification written in lane camera unit to store the specification in CONSULT. After Replace ECU Allows the writing of the vehicle information stored in CONSULT into the lane camera unit. Manual Configuration Allows the writing of the vehicle specification into the lane camera unit by hand.
- SAVING VEHICLE SPECIFICATION
WITH CONSULT Perform "READ CONFIGURATION" to save or print current vehicle specification. Is vehicle specification saved normally?
YES>>
GO TO 2.
NO>>
GO TO 4.
- REPLACE LANE CAMERA UNIT
Replace lane camera unit. Refer to LANE CAMERA UNIT : Removal and Installation .
>>
GO TO 3.
- WRITING VEHICLE SPECIFICATION
>>
GO TO 6.
- REPLACE LANE CAMERA UNIT
Replace lane camera unit. Refer to LANE CAMERA UNIT : Removal and Installation .
>>
GO TO 5.
- WRITING VEHICLE SPECIFICATION
- Select "WRITE CONFIGURATION - Manual selection"
- Touch "Next".
- Touch "OK".
- Check that the configuration has been successfully written and touch "End".
>>
GO TO 6.
- OPERATION CHECK
Confirm that following functions operate normally.
- LDW/LDP: Refer to Work Procedure .
>>
WORK END