Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Turn ignition switch ON.
4. Check the voltage ECM harness connector terminals under the following conditions.

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   E20	150 (APP sensor 1)	151	Accelerator pedal	Fully released	0.5 - 1.0
   				Fully depressed	4.2 - 4.8
   	143 (APP sensor 2)	144		Fully released	0.25 - 0.5
   				Fully depressed	2.0 - 2.5

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

GO TO 2.

Replace accelerator pedal assembly. Refer to ACCELERATOR PEDAL ASSEMBLY : Removal and Installation .

>>

INSPECTION END