Component Inspection

1. Turn ignition switch OFF.
2. Remove fuel injector relay.
3. Check the continuity between fuel injector relay terminals as per the following conditions.

   +	-	Conditions	Continuity
   Fuel injector relay
   Terminal
   3	5	12 V direct current supply between terminals 1 and 2	Existed
   		No current supply	Not existed
   6	7	12 V direct current supply between terminals 1 and 2	Existed
   		No current supply	Not existed

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace fuel injector relay.