Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform Refer to Work Procedure .
4. Turn ignition switch ON.
5. Set selector lever position to D.
6. Check the voltage between ECM harness connector terminals under the following conditions.

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   F92	78 (TP sensor 1 signal)	85 (Sensor ground)	Accelerator pedal	Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   	80 (TP sensor 2 signal)			Fully released	Less than 4.75
   				Fully depressed	More than 0.36

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

GO TO 2.

Replace electric throttle control actuator. Refer to INTAKE MANIFOLD : Removal and Installation .

>>

INSPECTION END