Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>

GO TO 2.

With CONSULT:

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Select "DATA MONITOR" mode With CONSULT:
4. Check the indication of "COOLAN TEMP/S".

With GST: Follow the procedure "With CONSULT: " above. Is the value of "COOLAN TEMP/S" between 5°C (41°F) and 36°C (97°F)?

YES>>

GO TO 3.

NO-1 [If it is below 5°C (41°F)]>>

Warm up the engine until the value of "COOLAN TEMP/S" reaches 15°C (59°F) or more. Retry from step 1.

NO-2 [If it is above 36°C (97°F)]>>

Cool engine down to less than 36°C (97°F). Retry from step 1.

With CONSULT:

1. Set the select lever in N range.
2. Start the engine and warm up in idle with the value of "COOLAN TEMP/S" between 5°C (41°F) and 40°C (104°F) for more than 15 seconds.
3. Check 1st trip DTC.

With GST: Follow the procedure "With CONSULT: " above. Is 1st trip DTC detected?

YES>>

Refer to DTC Diagnosis Procedure .

NO>>

INSPECTION END