Fuel Tank Pressure Sensor: Service and Repair

Removal Procedure
1. Raise the vehicle.
2. Remove the fuel tank. Refer to Fuel Tank Replacement.
3. Remove the fuel tank pressure sensor electrical connector.
4. Remove the fuel tank pressure sensor.

Installation Procedure
1. Install the fuel tank pressure sensor.
2. Install the fuel tank pressure sensor electrical connector.
3. Install the fuel tank. Refer to Fuel Tank Replacement.
4. Lower the vehicle.
5. Refill the fuel tank.
6. Connect the negative battery cable. Refer to Battery Disconnect Caution.
7. Inspect for fuel leaks through the following steps:
7.1. Turn the ignition switch to the ON position for two seconds
7.2. Turn the ignition switch to the OFF position for ten seconds.
7.3. Turn the ignition switch to the ON position
7.4. Check for fuel leaks.