Vehicle Speed Sensor: Service and Repair

Removal Procedure
1. Raise the vehicle. Suitably support the vehicle. Refer to General Vehicle Lifting and Jacking in General Information.
2. Disconnect the electrical connector from the sensor.
3. Remove the bolt.





4. Remove the sensor and the O-ring seal.
5. Inspect the seal and the transmission case. Replace the seal, if necessary.

Installation Procedure
1. Install the sensor and the O-ring seal to the transmission
2. Connect the electrical connector to the sensor.





3. Install the bolt.

Tighten
Tighten the bolt to 11 N.m (97 lb in).

4. Lower the vehicle.