LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2004 >> Rodeo 3.2 W, RWD, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Warning Systems >> Tire Pressure Monitoring System >> Tech 2 Scan Tool >> Programming TCU
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Programming TCU

  1. Follow Programming Tire ID Code Function steps 1 through 9.
  2. Select "Additional Function" and "Registration Mode" with the Tech 2.
  3. Check the TPMS light for blink as following figure.
  4. Set the transponder (J 46915) to following position on tire side.
    Fig 1: Setting Transponder
    G02799366Courtesy of ISUZU MOTOR CO.
  5. Enter the tire code with the transponder (J 46915) switch for 5 seconds.
  6. Tire code is registered in order of 1 to 5 using transponder (J 46915).

    Follow the tire pressure sensor location below.

    (For example of EOL) 

    Fig 2: Example Of EOL (Tire Pressure Sensor)
    G02799367Courtesy of ISUZU MOTOR CO.
  7. The tire registered into the 5th is registered as a spare tire.
  8. Blink of the TPMS light when shifting to Registration Mode is as follows.
  9. The TPMS light is turned OFF when the 5th registration is completed.
    Fig 3: TPMS Light Blinking Pattern
    G02799368Courtesy of ISUZU MOTOR CO.
scientia non olet · About LEMON Manuals