Sensor Housing

EGR Sensor & Housing:

- Remove Intake Elbow.
- Remove Intake Elbow/Throttle Hose.
- Remove Oil Filter Cartridge.
- Disconnect EGRT multi-plug.
- Slacken clip securing purge pipe hose to housing stub, remove hose and clip.
- Release EGR transfer pipe/housing union nut.
- Release housing to manifold securing bolts, remove housing.
- Remove distribution plate from housing and clean all gasket faces.
- Remove housing to transfer pipe adaptor.
- Remove EGR temperature sensor from housing. Discard the old housing.
- Reverse the procedure to fit the new housing. Use new gaskets.

Note: Use Hermetite exhaust jointing compound on the temperature sensor and pipe adaptor threads.
Wipe off the surplus after tightening the joints.