LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jaguar >> 1994 >> XJS 2D Convertible, 6.0 3 >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Crankshaft Position (CKP) Sensor >> Removal & Installation (6.0L)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation (6.0L)

  1. 6.0L models are equipped with 2 CKP sensors. One sensor (flywheel sensor) is located at rear of engine, and other sensor (TDC sensor) is located at lower front of engine.
  2. Disconnect negative battery cable. Raise and support vehicle. Remove heat shield (if removing flywheel sensor). Disconnect sensor wiring harness connector. Remove sensor bolts and sensor. To install, reverse removal procedure. Ensure sensor air gap is .018-.042" (.46-1.07 mm).
scientia non olet · About LEMON Manuals