Manifold Pressure/Vacuum Sensor: Service and Repair

Manifold Absolute Pressure (MAP) Sensor (18.30.86)

Removal
1. Remove the engine cover.
2. Remove the intake air resonator.
3. Disconnect the MAP sensor electrical connector.
4. Remove the MAP sensor.
- Remove the 2 Torx screws.
- Remove and discard the O-ring seal.







Installation
1. Install the MAP sensor.
- Clean the component mating faces.
- Install a new O-ring seal.
- Tighten the Torx screws.
- Connect the electrical connector.
2. Install the intake air resonator.
3. Install the engine cover.