Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor

Removal
1 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications [1][2]Battery
2
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.




3
NOTE:
Clean the components general area prior to dismantling.
Remove the crankshaft position (CKP) sensor.
- Disconnect the electrical connector.
- Remove the Torx screw.

Installation
1 Install the CKP sensor.
- Clean the component mating faces.
- Tighten the Torx screw to 8 Nm (6 lb.ft).
- Connect the electrical connector.
2 Connect the battery ground cable and install the cover. For additional information, refer to Specifications [1][2]Battery