P0333-22: Knock Sensor 2 Circuit High (Bank 2) - Signal amplitude > maximum: Action
- Vehicle Conditions to enable DTC Logging Strategy
- Refer to the appropriate system wiring diagrams and check knock sensor circuit for short circuit to power
- Measure knock sensor circuit for correct resistance
- Knock sensor resistance should be greater than 4 Mega Ohms
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check for abnormal engine noise that may corrupt the knock sensor signal
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest
- Check and install a new knock sensor as required