DTC U3000-49: Control Module - Internal electronic failure: Action

Using the Jaguar Land Rover Approved Diagnostic Equipment, clear the DTC and retest
If the fault persists, check and install a new vehicle dynamics control module
If a new vehicle dynamics control module is installed, the module will need to be calibrated using the following procedures. First, using the Jaguar Land Rover Approved Diagnostic Equipment, perform the Learn VIN routine (0x0404). Check this routine has been performed and completed successfully before proceeding. Next, with the ignition on and the vehicle stationary, using the Jaguar Land Rover Approved Diagnostic Equipment, perform the Calibrate Acceleration Sensor(s) routine (0x300F)