DTC U2300-51: Central Configuration - Not programed: Action
NOTE:
- After updating the car configuration file, set the ignition to on and wait 30 seconds before clearing the DTCs.
- The FlexRay wiring harness must not be repaired by making a localised wiring repair. A new wiring harness should be installed.
- Vehicle Conditions to enable DTC Logging Strategy
- Ignition on for 30 seconds
- Using the Jaguar Land Rover approved diagnostic equipment, check and update the car configuration file as necessary. Clear the DTCs and retest
- Refer to the electrical circuit diagrams and check the FlexRay bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, check the body control module for related DTCs and refer to the relevant DTC index