LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jaguar >> 2019 >> I-Pace First Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Supplemental Restraint System -- I-Pace/X590) >> Supplementary Restraint System (G2252058) >> Diagnosis And Testing >> Airbag And Safety Belt PRETENSIONER Supplemental Restraint System (G2217883) >> Occupant Classification Sensor Control. Module [OCSCM] Existing Module Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Occupant Classification Sensor Control. Module [OCSCM] Existing Module Programming

WARNING: This page is about a different car, the 2023 Jaguar I-Pace, 2022 Jaguar I-Pace, 2021 Jaguar I-Pace, and 2020 Jaguar I-Pace. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not attempt to install individual components from the Occupant Classification Sensor (OCS) service kit, as they are calibrated to function as a single assembly. The complete service kit consists of foam, occupant classification sensor bladder mat with attached smart digital pressure sensor. The Controller Area Network (CAN) type communication and LIN type communication OCS types are NOT interchangeable. Make sure the correct service kit for the vehicle is being used.
  1. Check the seat and make sure all electrical connectors are secure. Make sure the seat is correctly mounted and fixings are tightened to the correct torque. Refer to: FRONT ROW SEAT - VEHICLES WITH: POWER SEATS .
    NOTE: Make sure the vehicle is stationary and on a level surface. The seat must be secure and in an upright position before performing the next step. Failure to do this could induce a DTC  .
  2. Connect the Jaguar Land Rover approved diagnostic equipment
  3. Set the ignition to ON and wait 10 seconds. Make sure the SRS  warning lamp is illuminated during the ignition test cycle. The SRS  warning lamp should then extinguish after the 10 seconds to confirm no SRS  faults exist
    NOTE: All OCS Diagnostic Trouble Codes will be set in the RCM.
  4. Wait 5 seconds then set the OCS control module in to security access mode, after going in to an extended diagnostic session
  5. Using the Jaguar Land Rover approved diagnostic equipment, refer to datalogger signals ECU calibration Data #1 Number (0xF124), ECU Delivery Assembly Number (0xF113), ECU Core Assembly Number (0xF111), ECU Strategy Number (0xF188). Make a note of the OCS control module part number to make sure it is the correct part number for the vehicle
  6. Using the Jaguar Land Rover approved diagnostic equipment, check and update the OCS control module to the latest level software. Make sure the ignition is set to OFF and wait at least 5 seconds
  7. Set the ignition to ON and wait at least 125 seconds. This will allow sufficient time for Diagnostic Trouble Codes to log in the RCM if any are present
  8. Using the Jaguar Land Rover approved diagnostic equipment, check for OCS and Restraints Control Module (RCM) Diagnostic Trouble Codes stored in the RCM. If no Diagnostic Trouble Codes are found and no SRS  warning lamp is illuminated, no further action is necessary. If any Diagnostic Trouble Codes are found and/or the SRS  warning lamp is illuminated, refer to the relevant article of the repair information and perform the relevant repair actions as necessary. Re-perform this procedure to confirm the repair
scientia non olet · About LEMON Manuals