LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1979 >> Wagoneer Base >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Columns >> Removal & Installation >> All Models >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

All Models: Removal

  1. Disconnect battery ground cable. If equipped with automatic transmission, disconnect transmission shift rod at steering column shift lever.
  2. On Cherokee, Wagoneer and Truck models, it will be necessary to shift transmission to "1" detent position to gain access to shift rod retaining clip at shift lever.
  3. Remove upper steering shaft to intermediate shaft "U" joint pinch bolt. Do not attempt to separate upper steering shaft and intermediate shaft at this time.
  4. On Cherokee, Wagoneer and Truck models with air conditioning, remove left duct extension. Remove steering column to instrument panel bezel. On Cherokee and Wagoneer models, bezel screws are located behind lower bezel.
  5. Remove bolts securing steering column mounting bracket to instrument panel. Remove bolts securing mounting bracket to steering column and remove bracket.
    CAUTION: It is recommended that the bracket be stored in a safe place to prevent damage to breakaway capsules.
  6. Remove upper and lower toe-plates. On vehicles with automatic transmission, disconnect wiring terminal at neutral safety switch. Disconnect electrical connectors at ignition switch, disconnecting black connector first. Disconnect directional signal switch connector.
  7. If equipped with Cruise Command, disconnect electrical connector. Separate steering shaft from intermediate "U" joint and remove steering column assembly.
    CAUTION: It is recommended that steering column be handled with care after removal. Blows on end of steering shaft or shift levers, leaning on column assembly, or dropping unit may cause damage to energy absorbing components.
scientia non olet · About LEMON Manuals