LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1990 >> Wrangler S >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor R & I >> Disassembly
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Distributor R & I: Disassembly

  1. With distributor removed from engine, remove rotor. Position distributor in a vise. Remove distributor gear from shaft using a small punch and hammer to drive out retaining roll pin. See Fig 1 . Remove distributor shaft from housing.
    Fig 1: Exploded View Of Distributor (4.0L)
    G90H17084Courtesy of CHRYSLER MOTORS.
  2. Remove stator retaining screw. See Fig 2 . Mark location of stator position for assembly reference. Remove stator harness by pushing grommet through housing. Remove stator assembly.
Fig 2: Stator Removal & Installation (4.0L)
G90I17085Courtesy of CHRYSLER MOTORS.
scientia non olet · About LEMON Manuals