Verification Test SP-VER, Cruise Control Verification

Reconnect and reassemble all previously tested components. If Single Board Engine Controller has been changed, perform the following:

• If vehicle is equipped with factory theft alarm, start vehicle at least 20 times so alarm system may be activated when desired.
• Write vehicle's odometer mileage to memory location within replacement SBEC. This will enable new SBEC to operate Emission Maintenance Reminder (EMR) light properly. See MILEAGE TRANSFER under DRB-II TEST FUNCTIONS in appropriate TESTS W/CODES article in the ENGINE PERFORMANCE Section.
• Connect DRB-II to engine diagnostic connector and erase faults.

To ensure no other faults remain, perform the following:

1. Road test vehicle at a speed of above 35 MPH. Put cruise control ON/OFF switch in ON position. Depress and release SET switch. If cruise control did not engage, repair is not complete. Check all pertinent TECHNICAL SERVICE BULLETINS (TSBs) and return to TEST SP-1A  , if necessary.
2. Depress and release SET switch. If vehicle speed did not increase by 2 MPH, repair is not complete. Check all pertinent TECHNICAL SERVICE BULLETINS (TSBs) and return to TEST SP-1A  , if necessary.
3. Depress and release brake pedal. If cruise control did not disengage, repair is not complete. Check all pertinent TECHNICAL SERVICE BULLETINS (TSBs) and return to TEST SP-1A  , if necessary.
4. Bring vehicle speed back up to 35 MPH. Depress RESUME/ACCEL switch. If cruise control did not resume the previously set speed, repair is not complete. Check all pertinent TECHNICAL SERVICE BULLETINS (TSBs) and return to TEST SP-1A  , if necessary.
5. Hold down SET switch. If vehicle did not decelerate, repair is not complete. Check all pertinent TECHNICAL SERVICE BULLETINS (TSBs) and return to TEST SP-1A  , if necessary.
6. Ensure vehicle speed is greater than 35 MPH and release SET switch. If vehicle did not adjust and set to new vehicle speed, repair is not complete. Check all pertinent TECHNICAL SERVICE BULLETINS (TSBs) and return to TEST SP-1A  , if necessary.
7. Turn ON/OFF switch to OFF position. If cruise control did not disengage, repair is not complete. Check all pertinent TECHNICAL SERVICE BULLETINS (TSBs) and return to TEST SP-1A  , if necessary.
8. If vehicle successfully passed all previous tests, cruise control system is now functioning correctly. Repair is complete.