LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1992 >> Cherokee Base, 4D Utility, 2.5 P, 4WD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Synchronization Signal Generator >> Removal & Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal & Installation

  1. Remove distributor cap, rotor, and distributor. Remove pulse ring mounting screws and remove pulse ring. Using pin punch and hammer, remove distributor gear roll pin.
  2. Using a rubber mallet, tap distributor shaft out until distributor gear and shim are removed. Slide shaft out of distributor housing. Remove sync (synchronization) signal generator stator mounting screws and positioning arm.
  3. Slide wiring harness grommet out of distributor housing. Remove synch signal generator. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals