LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1992 >> Cherokee Limited >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - Aw-4 >> Component Disassembly & Reassembly >> Overdrive Support >> Reassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Overdrive Support: Reassembly

  1. To reassemble, reverse disassembly procedure. Lubricate NEW seal rings and "O" rings with ATF before installing. Squeeze ends of seal ring together before installing on overdrive support. This aids in proper seating of seal rings.
  2. Ensure tangs on rear race engage with slots on overdrive support. Thrust bearing must be installed with rollers facing upward (away from overdrive support).
  3. Ensure piston moves smoothly by placing overdrive support on direct clutch drum and applying compressed air through overdrive support feed hole. Verify thrust bearing and race size identification for proper location by measuring inside and outside diameter. See OVERDRIVE SUPPORT BEARING & RACE IDENTIFICATION  .
OVERDRIVE SUPPORT BEARING & RACE IDENTIFICATION

Application Outside Diam.: In. (mm) Inside Diam.: In. (mm)
Front Race 1.882 (47.80) 1.209 (30.71)
Rear Race 1.882 (47.80) 1.350 (34.29)
Thrust Bearing 1.878 (47.70) 1.287 (32.69)
scientia non olet · About LEMON Manuals