LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1995 >> Cherokee Country, 4WD, Part Time, Automatic >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless Entry Systems >> Removal & Installation >> Keyless Entry Module (Receiver) >> Removal & Installation (Without Overhead Console)
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal & Installation (Without Overhead Console)

  1. Remove two screws attaching receiver housing to headlining. See Fig 1 .
  2. Pull housing toward rear of vehicle to disengage clip.
  3. Disconnect receiver harness connector.
  4. Remove circuit board from housing.
  5. To install, reverse removal procedures.
Fig 1: Removing Keyless Entry Module Housing
G00107464Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals