LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1996 >> Grand Cherokee Orvis >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Testing >> Vehicle Communications Tests >> Test 12E - Bus Short To Battery
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 12E - Bus Short To Battery

  1. Turn ignition off. Using external ohmmeter, measure resistance passenger door module 12-pin connector, terminals No. 3 (Gray/Black wire) and No. 8 (Violet/Brown wire). If resistance is less than 5 ohms, repair short between Gray/Black wire and Violet/Brown wire. If resistance is 5 ohms or greater, go to next step.
  2. Measure resistance passenger door module 12-pin connector, terminals No. 4 (Dark Green/White wire) and No. 8 (Violet/Brown wire). If resistance is less than 5 ohms, repair short between Dark Green/White wire and Violet/Brown wire. If resistance is 5 ohms or greater, go to next step.
  3. Measure resistance passenger door module 12-pin connector, terminals No. 3 (Gray/Black wire) and No. 9 (White/Black wire). If resistance is less than 5 ohms, repair short between Gray/Black wire and White/Black wire. If resistance is 5 ohms or greater, go to next step.
  4. Measure resistance passenger door module 12-pin connector, terminals No. 4 (Dark Green/White wire) and No. 9 (White/Black wire). If resistance is less than 5 ohms, repair short between Dark Green/White wire and White/Black wire. If resistance is 5 ohms or greater, go to next step.
  5. Measure resistance passenger door module 12-pin connector, terminals No. 8 (Violet/Brown wire) and No. 11 (Pink wire). If resistance is less than 5 ohms, repair short between Violet/Brown wire and Pink wire. If resistance is 5 ohms or greater, go to next step.
  6. Measure resistance passenger door module 12-pin connector, terminals No. 9 (White/Black wire) and No. 11 (Pink wire). If resistance is less than 5 ohms, repair short between White/Black wire and Pink wire. If resistance is 5 ohms or greater, replace passenger door module.
NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAM  . After each repair, perform VERIFICATION TEST VER-1.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
NOTE: Check all appropriate BCM circuits for short to CCD bus circuits. See wiring diagram. Repair as needed. Following testing are the most common examples.
scientia non olet · About LEMON Manuals