Test 13B - Bus Short To 5 Volts
- Turn ignition off. Using external ohmmeter, measure resistance between Powertrain Control Module (PCM) Gray connector, terminal C30 (Violet/Brown wire) and Black connector, terminal A17 (White/Black wire). PCM is located at right corner of firewall. If resistance is less than 5 ohms, repair short between Violet/Brown wire and White/Black wire. If resistance is 5 ohms or greater, go to next step.
- Measure resistance between PCM Gray connector, terminal C28 (White/Black wire) and Black connector, terminal A17 (White/Black wire). If resistance is less than 5 ohms, repair short between White/Black wires of both connectors. See wiring diagram for clarification. If resistance is 5 ohms or greater, replace PCM.
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION
and WIRING DIAGRAM
. After each repair, perform VERIFICATION TEST VER-1.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.