Power Window Test 5C - Inoperative Right Rear Window Motor

NOTE: Perform POWER WINDOW TEST 5A before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION and WIRING DIAGRAM and POWER WINDOWS article. Perform TEST VER-1A after each repair.

CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.

Turn ignition off. Disconnect right rear door window switch connector. Using scan tool in ohmmeter mode, measure resistance at terminal No. 6 (Black wire) on right rear door window switch connector. If resistance is more than 5 ohms, repair open in Black wire. If resistance is 5 ohms or less, replace rear door window switch.