Test 13B - Bus Short To 5 Volts
- Turn ignition off. Using external ohmmeter, measure resistance between terminal C30 (Violet/Brown wire) on Powertrain Control Module (PCM) Gray connector and terminal A17 (White/Black wire) on PCM Black connector. PCM is located at right corner of firewall. If resistance is less than 5 ohms, repair short between Violet/Brown wire and White/Black wire. If resistance is 5 ohms or greater, go to next step.
- Measure resistance between terminal C28 (White/Black wire) on PCM Gray connector and terminal A17 (White/Black wire) on PCM Black connector. If resistance is less than 5 ohms, repair short between White/Black wires of both connectors. See wiring diagram for clarification. If resistance is 5 ohms or greater, replace PCM.
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION
and WIRING DIAGRAM. Perform VERIFICATION TEST VER-1 after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.