LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1997 >> Wrangler SE, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.5L >> Trouble Code Tests >> Test TC-35C - No Vehicle Speed Sensor Signal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test TC-35C - No Vehicle Speed Sensor Signal

NOTE: Perform TEST TC-35A before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS article.
  1. Disconnect Powertrain Control Module (PCM) connectors. Inspect connectors and terminals for damage. Repair connectors and terminals as necessary and perform TEST VER-2A. If connectors and terminals are okay, go to next step.
  2. Using scan tool in voltmeter mode, check voltage on signal circuit (White/Orange wire) between VSS connector and PCM White connector. If voltage is more than 4.5 volts, replace PCM and perform TEST VER-2A. If voltage is 4.5 volts or less, repair open signal circuit and perform TEST VER-2A.
scientia non olet · About LEMON Manuals