LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1998 >> Grand Cherokee 5.9 Limited >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> System Testing >> Vehicle Communications >> Test 13E - Bus Short To Battery
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 13E - Bus Short To Battery

  1. Turn ignition off. Using external ohmmeter, measure resistance between terminals No. 3 (Gray/Black wire) and No. 8 (Violet/Brown wire) on passenger door module 12-pin connector. If resistance is less than 5 ohms, repair short between Gray/Black wire and Violet/Brown wire. If resistance is 5 ohms or greater, go to next step.
  2. Measure resistance between terminals No. 4 (Dark Green/White wire) and No. 8 (Violet/Brown wire) on passenger door module 12-pin connector. If resistance is less than 5 ohms, repair short between Dark Green/White wire and Violet/Brown wire. If resistance is 5 ohms or greater, go to next step.
  3. Measure resistance between terminals No. 3 (Gray/Black wire) and No. 9 (White/Black wire) on passenger door module 12-pin connector. If resistance is less than 5 ohms, repair short between Gray/Black wire and White/Black wire. If resistance is 5 ohms or greater, go to next step.
  4. Measure resistance between terminals No. 4 (Dark Green/White wire) and No. 9 (White/Black wire) on passenger door module 12-pin connector. If resistance is less than 5 ohms, repair short between Dark Green/White wire and White/Black wire. If resistance is 5 ohms or greater, go to next step.
  5. Measure resistance between terminals No. 8 (Violet/Brown wire) and No. 11 (Pink wire) on passenger door module 12-pin connector. If resistance is less than 5 ohms, repair short between Violet/Brown wire and Pink wire. If resistance is 5 ohms or greater, go to next step.
  6. Measure resistance between terminals No. 9 (White/Black wire) and No. 11 (Pink wire) passenger door module 12-pin connector. If resistance is less than 5 ohms, repair short between White/Black wire and Pink wire. If resistance is 5 ohms or greater, replace passenger door module.
NOTE: For connector terminal identification, refer to CONNECTOR IDENTIFICATION  . For wiring diagrams, refer to WIRING DIAGRAMS  . After each repair, perform TEST VER-1A  .
CAUTION: Always turn ignition off prior to disconnecting any module connector.
NOTE: Check all appropriate BCM circuits for short to CCD bus circuits. See wiring diagram. Repair as needed. Following testing are the most common examples.
scientia non olet · About LEMON Manuals