Power Mirror Switch: Service and Repair

REMOVAL AND INSTALLATION
This procedure covers removal of the stand-alone type power mirror switch. Vehicles with power windows and power locks have a power mirror switch which is integral to the Driver Door Module (DDM). See Door Module for the DDM-type power mirror switch service procedures.

1. Disconnect and isolate the battery negative cable.

Stand-Alone Power Mirror Switch Remove/Install:

2. Using a trim stick or another suitable wide flat-bladed tool, gently pry around the perimeter edge of the switch to release the snap clips that secure the switch to the trim panel.
3. Pull the power mirror switch away from the trim panel far enough to access the wire harness connector.
4. Unplug the power mirror switch from the wire harness connector.
5. Reverse the removal procedures to install.