Stand-Alone Switch
Disconnect negative battery cable. Remove power window switch. See STAND-ALONE POWER MIRROR SWITCH under REMOVAL & INSTALLATION. Place mirror select switch in left or right mirror mode. Continuity should exist between specified terminals when each control button is depressed. See STAND-ALONE POWER MIRROR SWITCH CONTINUITY table. See Fig 1 . If continuity is not as specified, replace switch.
STAND-ALONE POWER MIRROR SWITCH CONTINUITY
| Switch Position | Terminals No. | |
|---|---|---|
| Left Mirror | ||
| Off | 1 & 5; 1 & 6; 1 & 7; 1 & 8 | |
| Up | 2 & 8; 1 & 5; 1 & 6; 1 & 7 | |
| Down | 2 & 5; 1 & 6; 1 & 7; 1 & 8 | |
| Left | 2 & 7; 1 & 5; 1 & 6; 1 & 8 | |
| Right | 2 & 6; 1 & 5; 1 & 7; 1 & 8 | |
| Right Mirror | ||
| Off | 1 & 3; 1 & 4; 1 & 5; 1 & 6 | |
| Up | 2 & 4; 1 & 3; 1 & 5; 1 & 6 | |
| Down | 2 & 5; 1 & 3; 1 & 4; 1 & 6 | |
| Left | 2 & 3; 1 & 4; 1 & 5; 1 & 6 | |
| Right | 2 & 6; 1 & 3; 1 & 4; 1 & 5 | |